Duffy ties FAA ground stop to contractor's copper-to-fiber work
The transportation secretary says a router flooded the air traffic network after L3Harris upgraded a remote site. Officials have not yet found the root cause.
Key takeaways
- Duffy said the Nov. 13 ground stop followed L3Harris work to move a remote FAA site from copper lines to fiber.
- He said a router then flooded other routers with more than 1,000 connection attempts every four to five seconds, disrupting communications and radar feeds.
- Duffy said officials are working to determine whether L3Harris made an installation error or a faulty router was to blame; a root cause analysis is under way.
- L3Harris says it is supporting the FAA's investigation and takes the ground stop's impact seriously.
- FAA head Bryan Bedford said there was zero evidence of anything nefarious or AI-related.
The nationwide ground stop that halted US departures on Nov. 13 followed work by contractor L3Harris Technologies to move a remote Federal Aviation Administration site from copper telecommunication lines to fiber, Transportation Secretary Sean Duffy said at a press conference on Saturday, Nov. 14. He said investigators had not yet determined what the fault was, CNBC, TechCrunch, Fox Business and The Epoch Times report.
What did officials say happened?
Duffy described the work as routine maintenance, according to Fox Business and TechCrunch, and CNBC reports he said it took place at "at least" one remote location. After the switch, a router there flooded other routers in the air traffic control network with more than 1,000 connection attempts every four to five seconds, he said, causing problems with communications to aircraft and radar feeds, according to The Epoch Times. CNBC reported the interval as roughly every five seconds.
FAA acting chief technology officer Rebecca Guy described two places pinging the agency's network at a very high rate, according to TechCrunch. She said the FAA switched both off to stabilize the network and is now doing a root cause analysis.
FAA Administrator Bryan Bedford said no FAA facilities went dark, but the agency grounded flights because of instability in the information feeds to air traffic control centers that it could not explain, CNBC reports. He said the FAA was unwilling to take the risk that the problem would spread and cut a center's connection with aircraft. Bedford said there was "zero evidence" of anything nefarious or anything related to artificial intelligence, according to CNBC and TechCrunch.
Who is responsible?
Duffy said officials were working out whether the cause was user or installation error by L3Harris or a faulty router it had installed, CNBC, TechCrunch and Fox Business report. Officials also cited routers and networking equipment from Cisco as well as L3Harris, CNBC reports, and Bedford said routine router replacements are separate from the FAA's modernization program. Bedford said the agency was still working out what the defective piece of equipment was, according to TechCrunch. Duffy criticized contractors that he said take the government's money and provide poor service, according to The Epoch Times, and said L3Harris owns the legacy network the FAA uses, according to Fox Business. Duffy said he would remain dependent on L3Harris until a new system is built with other telecom companies, which Fox Business reports he named as AT&T, Verizon and Lumen.
L3Harris said it is "supporting the FAA in its investigation to understand the conditions that led to the Nov. 13 ground stop," and that it treats the disruption to passengers, airlines and air traffic as a serious matter, according to CNBC and Fox Business. In a statement on X, reported by CNBC, and in a statement to Fox News Digital, the company said it and its partners have completed more than 70% of the planned move of airspace communications from copper wires to fiber optics.
Why was the work done on a Friday afternoon?
Asked why the switch happened on a Friday afternoon, Duffy said that changeovers at large airports are done late at night but remote ones happen during the day, and that the timing of such work would be reevaluated, TechCrunch reports. Before Saturday's briefing, Washington Examiner reporter Anna Giaritelli told CNN that air traffic controllers she had spoken to doubted the administration's account, saying such switchovers are normally done midweek and overnight rather than on a busy Friday afternoon, according to Common Dreams.
How big was the disruption?
Counts differ by tracker and time. CNBC, citing FlightAware, reported more than 9,000 US cancellations on Friday, though it noted some disruptions were due to bad weather, and thousands more cancellations on Saturday. The ground stop lasted more than four hours, CNBC and The Epoch Times report.
Duffy has used the outage to renew calls for Congress to fund a new air traffic control system, and Fox Business reports he is seeking $50 billion. Officials have said they do not believe the outage was a cyberattack, according to CNBC and The Epoch Times.
Questions readers are asking
What caused the FAA ground stop on Nov. 13?
Officials have not found the root cause. Duffy said it followed L3Harris work to switch a remote site from copper to fiber, after which a router flooded other routers in the network with connection attempts.
Was it a cyberattack?
Officials say they do not believe so. FAA Administrator Bryan Bedford said there was zero evidence of anything nefarious or anything related to AI.
What did L3Harris say?
L3Harris said it is supporting the FAA's investigation, takes the ground stop's impact seriously and has completed more than 70% of the planned move from copper wires to fiber optics.
Why was the work done on a Friday afternoon?
Duffy said changeovers at large airports are done late at night but remote ones happen during the day, and that the timing of such work would be reevaluated, according to TechCrunch.
Sources
- CNBC: Ground stop followed contractor upgrade to L3Harris telecom system: Duffy
- CNBC: 'Root cause' of nationwide ground stop is unknown, FAA says
- TechCrunch: Transportation secretary blames 'routine' equipment upgrade for grounding flights nationwide
- Fox Business: Sean Duffy says L3Harris work may have caused FAA nationwide ground stop
- Common Dreams: 'Duffy Lied': Air Traffic Controllers Refute Trump Transportation Secretary's Ground Stop Explanation
- The Epoch Times: Faulty Router or Contractor Error May Have Triggered FAA Ground Stop, Duffy Says
- #faa
- #air-traffic-control
- #outage
- #critical-infrastructure
- #l3harris
Get the day's top AI & tech stories on WhatsApp: Follow the NextFish channel
Get stories like this every morning.
Related
Cybersecurity3 min
FBI reportedly examines software update after FAA ground stop
A telecom failure halted US departures for more than four hours on Friday. Officials see no sign of a cyberattack, and accounts of the cause vary in detail.
Policy & Safety3 min
FAA expands its SMART AI traffic system to all 22 US en route centers
The agency says the system helped reroute 180 flights in its Washington-area trial. Lawmakers have asked how it was tested; the controllers' union says it was not involved.
Big Tech3 min
Microsoft 365 outage hits Outlook, Teams and Copilot for hours worldwide
Microsoft says servers unexpectedly dropped out of service, straining the rest. By Friday the company had apologized and said it was seeing broad recovery.
Policy & Safety3 min
Australia plans mandatory safety rules and regulator for frontier AI
Frontier AI companies operating in Australia would have to allow independent evaluation of their models and report incidents quickly. Details of the law are still to come.